Flux Technology Inc. is recalling 91 units of the Lazervida 10W Diode Laser Engraver with Lazervida shield. The device does not meet federal laser safety standards because it is missing essential safety components, including a beam attenuator, a key switch, and a remote interlock connector. Consumers should stop using the product immediately as the lack of these safety features could lead to accidental laser exposure.
The engraver lacks required safety interlocks and shielding, which increases the risk of accidental exposure to the laser beam. Such exposure can cause permanent eye damage or skin burns. No incidents or injuries have been reported to date.
You have 2 options:
Recall Number: Z-1878-2025. The product lacks required labels and manual instructions required under current regulations.
If you or a family member were harmed by this recalled product, you may have legal rights. Consider consulting a consumer protection attorney to understand your options for compensation.
This is general information, not legal advice. Go Backs is not a law firm and does not provide legal services.
AI-Enhanced Content: The summary, action steps, and risk assessment on this page were generated by AI from official government recall data to improve readability. This is not legal or medical advice. Always refer to the official agency sources below for authoritative information.
Sources: FDA iRES · Raw API Response
openFDA Disclaimer: This recall information is sourced from the openFDA API. Do not rely on openFDA to make decisions regarding medical care. While we make every effort to ensure that data is accurate, you should assume all results are unvalidated. Refer to the openFDA terms of service for more information.